A constant hum or buzz in a recording
Checked against the product on October 22, 2026
A steady hum or buzz comes from electrical interference, a faulty cable, a nearby appliance or a fan. Find the source while you listen with headphones, switch it off or move away, check cables and power, and record a short test. Software can reduce a mild hum, but a clean recording is always better than a repaired one.
What you are seeing
A low, steady tone sits underneath the voice for the whole recording, or a buzz appears when a light dimmer, charger or screen is near the microphone. It may be barely noticeable on speakers but obvious on headphones.
How to fix it
- Listen with headphonesBefore you record.
- Switch off nearby devicesFridge, fan, charger, air conditioning.
- Move away from screens and lightsEspecially dimmers.
- Check cables and connectorsTry another cable.
- Unplug a laptop charger to testRun on battery.
- Record a short testTen seconds of silence.
- Reduce a mild hum with noise reductionGently.
- Record again if it remainsA clean take wins.
Common causes
- Electrical interference from a charger or dimmer.
- A cheap or damaged cable.
- A fan, fridge or air conditioner.
- A microphone too far away, so gain is raised.
- A ground loop between devices.
What to avoid
Do not apply strong noise reduction that makes the voice sound watery, and do not ignore the hum because it is quiet on your speakers. Captions can lose accuracy when a constant tone sits under quiet words.
In Averoai.pro
Averoai.pro transcribes the speech in your video, so a clean recording gives more accurate captions. A constant hum can lower accuracy, and fixing it at the source is the most reliable improvement.
A worked example
A host noticed a buzz in a recording made while a laptop charged. Running on battery and moving a lamp with a dimmer away from the microphone removed it, and the transcript contained far fewer errors than the previous episode.
Worth remembering
A hum is easier to prevent than to repair. Listen first with headphones, remove the source and test for ten seconds before every session. Keep the list of devices that caused trouble near your recording spot, and add a note whenever you discover a new one, so that a clean recording becomes a habit rather than a lucky accident. If a hum appears only sometimes, note the time of day and what was switched on, because intermittent sources such as a fridge compressor or a neighbour's equipment follow patterns that become obvious after two or three recordings.
Frequently asked questions
Why is there a hum?
Often interference, a cable or an appliance.
Can software remove it?
A mild hum, partly.
How do I find the source?
Listen with headphones and switch things off.
Does hum affect captions?
It can reduce accuracy.
Features that help with this
Related reading
- A clip whose audio was muted because of music
A platform can mute or restrict a clip when it detects protected music. Learn why it happens, how to check your rights and how to avoid it next time.
- An analysis that takes longer than expected
A long analysis can be normal for a long video, but sometimes something slows it down. Learn what affects the time and what you can do while you wait.
- Handling noise and clothing rustle in recordings
Bumps, rubbing fabric and a moving microphone spoil clean speech. Learn how to mount the mic, place a lavalier and record again when the noise cannot be saved.
- Wind noise in outdoor recordings
Wind rumble drowns speech and ruins captions. Learn how to shield the microphone, change position and record again so outdoor clips stay clear.
- What is variable frame rate?
Variable frame rate changes the number of frames per second as a recording runs. Learn why it can drift out of sync and how to convert it to constant.
- What is reverb in a recording?
Reverb is the wash of reflections that follows a sound in a room. Learn why hard, empty rooms sound boomy and what simple steps make speech clearer.
Also available in Français